Product Manual

28
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
26
Low voltage/motor overload. Check that power supply is adequate and that compressor is
on a dedicated circuit. If using extension cord, try using without.
If compressor is connected to a circut protected by a fuse, use
time delay fuses.
27
Restricted air passages. Inspect and replace transfer tubes or check valve, as
required.
28
Low voltage motor. Furnish adequate power.
29
Bad check valve. Replace check valve.
30
Seized pump. Contact a D e WALT factory service center or a D e WALT authorized
service center.
31
Oil level too high. Reduce to proper level. See Compressor Pump Oil under
Maintenance.
32
Poor ventilation. Relocate compressor to an area with cool, dry, well circulated
air, at least 12 in. from nearest wall.
33
Dirty cooling surfaces. Clean all cooling surfaces thoroughly.
34
Too much back pressure in tank. Open drain valve when starting motor.
35
Compressor too cold. Move compressor to a warmer location.