Use and Care Manual

22
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
13 Engine mount ing bolts are loose Tighten mounting screws. Torque engine mounting bolts to
10– 20 ft.-lbs. (13.5–27.1 Nm).
WARNING: Risk of bursting. Excessive vibration could weaken
the air tank and cause it to rupture or explode. Mounting screws
must be kept tightened.
14
Air tank pressure is too high Open the regulator and reduce air tank pressure to less than
40 psi.
15
Engine problem Contact a D e WALT factory service center or a D e WALT authorized
service center.
16
Engine oil is low See engine instruction manual.
17
It is normal for some pressure drop to occur If there is an excessive amount of pressure drop when the
accessory is used, adjust the regulator as instructed in Regulator
under Features.
NOTE: Adjust the regulated pressure under flow conditions while
accessory is being used.
18
Damaged regulator Replace.
19
Manual lock unloader lever in open position Rotate manual lock unloader lever to the closed perpendicular
position.
20
Regulator open Rotate the regulator knob counterclockwise to its built-in stop.
21
Engine fuel tank empty Add gasoline, see engine's instruction manual for correct procedure.