Use and Care Manual

ENGLISH

Installing and Adjusting the

Handle

Installing the Handle

1. Press and hold the handle base against the

underside of the upper shaft housing (Fig. 4).

2. Press the handle top onto the handle base

until they snap together (Fig. 4).

3. Insert the bolts (x4) into the holes (x4) (Fig. 4).

4. Tighten the bolts, but do not tighten them

completely. Use a 5/32-inch (4 mm) Allen

wrench.

5. Hold the unit in the operating position (Fig. 13).

Move the handle up or down the upper shaft

housing to a comfortable location (Fig. 5).

Make sure the handle is positioned beyond

the end of the safety label (Fig. 5).

6. Tighten the bolts until the handle is secure.

ASSEMBLY - Continued

Fig. 2

Coupler Attachment

Fig. 3

Release Button

90˚ Hole