Installation Guide

Need Help?
Call 1-855-971-1123
ASSEMBLY TOOLS REQUIRED
• Phillips Screwdriver
50:1
Mix thoroughly in a separate fuel
can:
– 2.6 fl. oz. of 2-cycle engine oil
– 1 gallon of fresh unleaded
gasoline (less than 30 days old)
NOTE: Do not mix directly in the
unit fuel tank.
Position the unit with the fuel cap
facing up. Slowly remove the fuel
cap. Fill the fuel tank. Reinstall
the fuel cap. Move the unit at
least 30 ft. (9.1 m) from the fuel
container and the fueling site
before starting the engine.
8
9
Read the operator’s manual
thoroughly before operating
the unit. Follow all warnings and
safety instructions. This fast
guide is intended as a reference
for users that have already read
the operator's manual and are
familiar with the necessary safety
precautions.
Align the release button with the
guide recess. Push the
attachment straight into the
coupler until the release button
snaps firmly into the primary
hole. Turn the knob clockwise to
tighten the coupler.
Remove the hanger cap from the
attachment. If present, remove
the gray spacer from the coupler.
Turn the knob counterclockwise
to loosen the coupler.
1 2 3
778-18679 / 00 01/20
Push the strap up through the
center slot in the buckle. Bend
the strap over and push it down
through the lower slot in the
buckle.
Put the shoulder strap over the
operator’s head and onto the left
shoulder.
Place the handle between the top
clamp and middle clamp. Place
the clamps and handle over the
upper shaft housing and onto the
bottom clamp. Make sure the
curved portion of the handle is on
the operator's left. While holding
the pieces together, insert the
bolts (x4) into the aligned holes.
Screw a nut onto the end of a
bolt, but only slightly. Push the
nut into the hexagonal recess on
the bottom clamp. Hold the nut
in place. Tighten the bolt with a
Phillips screwdriver, but do not
tighten it completely . Repeat this
step for each nut and bolt.
Hold the unit in the operating
position and slide the handle in
or out of the clamp until the
arrow/line on the decal touches
the clamp. Angle the handle
forward or backward, as desired.
Tighten the bolts with a Phillips
screwdriver until the handle is
secure.
4
5
6
7
Choke Lever
Starter Rope Grip
Fuel Cap
Throttle Control
Upper Shaft Housing
On / Off Switch
Primer
Bulb
Handle
Coupler
Throttle Lockout
Shoulder Strap / Harness Loop
IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW
THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Lea la traducción en Español en el manual.
ASSEMBLY