RIS TN INSTALLING AND REMOVING THE ATTACHMENT The couplet enables the use of various optional attachments. understand the manual that came with the attachment. g WARNING: Before using any attachment, read and Follow all safety information contained within. damage to the unit, shut the unit off bis fore removing ar installing an attachment. g WARNING: 1o avoid serious personal in fury and installing the Attachment 1. Remove the hanger cap from the attachment.
INSTALLING AND ADJUSTING THE HANDLE stalling the Handle 1. 2. Place the handier between the top clamp and middies clamp Fig. 4), ¥ necessary, rotate or #ip the middle clamp unit the holes in the top clamp and middle camp align. Place the clamps and handle over the upper shaft housing and onto the bottom clamp {Fig. 4}, NOTE: Make sure the curved portion of the handier is on the 3 4 operator’s left {Fig. 4). While holding the pieces together, insert the bolts (xd) into the aligned holes (Fig. 4).
ASSEMBLING AND USING THE SHOULDER STRAP Assembling the Shoulder Strap 1. Push the strap up through the center slot in the bucks (Fig. 8). 2. Bend the strap over and push it down through the lower slot in the buckle (Fig. 8). Using the Shoulder Strap 1. Put the shoulder strap over the operator's head and onto the left shoulder (Fig. 8. 2. Start the unit, Refer to Starting and Stopping. 3. Snap the clip onto the shoulder strap / harness loop (Fig. 7). 4, Adjust the shoulder strap to fit the operator Fig. 8).