Use and Care Manual

14
CAUTION:CAUTION:
POWER SUPPLY
This pressure washer shall only be used with a dedicated
receptacle/plug rated 120vAC, 60 Hz at 15 -or- 20 amperes.
Any other appliances on the circuit should be turned o or
unplugged when using the pressure washer. Never use the
pressure washer with an adapter that may lead to higher
voltage or excessive current. Excessive current may trip circuit
breaker. Consult a qualied electrician if unsure of the desired
power supply receptacle’s ability to safely power this pressure
washer.
IT IS NOT RECOMMENDED TO USE AN
EXTENSION CORD. If, however, an extension
cord is required, it must be an OUTDOOR RATED
3-PRONG CORD, that is no longer than 50 feet (15M)
and has a minimum of 14 AWG (2.5mm2) conductors. Always
uncoil the extension cord when in use. DO NOT use an
extension cord that has its ground pin damaged or missing.
7. Plug electrical power cord into an electrical circuit rated
for 120 Volts AC at 15 Amps that is properly installed
in accordance with all local codes and ordinances. The
indicator light on the GFCI should be ON.
NOTICE The power supply must be 120 V, 60 Hz and a minimum
15 amp dedicated circuit.
B
D
C
NOTICE The indicator light must be ON for the electric pressure
washer to operate.
WARNING Risk of electrocution. Non-operating ground
fault circuit interrupter (GFCI) could result in death
or bodily injury. If indicator light does not stay ON
after test and reset, do not use GFCI.
8. Press TEST button (B). The indicator light (D) should be OFF.
B
D
C
Operation
Start Pressure Washer
Follow the instructions below in the order presented.
WARNING Risk of eye injury.
Spray could splash back or propel objects resulting
in serious injury.
Always wear indirect vented (chemical splash)
safety goggles marked to comply with ANSI Z87.1 when
using or in vicinity of this equipment. NEVER substitute
safety glasses or dry-condition goggles for indirect vented
safety goggles.
1. Place the electric pressure washer near an outside water
source capable of supplying water at a ow rate greater than
5 GPM (18.9 LPM) and no less than 20 PSI (1.38 BARS) at the
electric pressure washer end of garden hose. DO NOT siphon
supply water.
2. Connect garden hose to water inlet.
3. Check that high pressure hose is tightly connected to spray
gun and high pressure outlet. See Connect Hoses and Water
Supply.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
4. Turn ON water, point gun in a safe direction, open trigger lock
small lever and squeeze trigger to purge pump system of air.
5. Install desired spray tip into wand. See Connect Wand and
Spray Tips.
6. Turn master ON/OFF switch (C) to OFF (0) position
DANGER:DANGER:
ELECTROCUTION HAZARD
Improper connection of the equipment grounding conductor
can result in the risk of electrocution. Check with a qualied
electrician if you are in doubt as to whether the receptacle is
properly grounded. DO NOT modify the plug provided with
this product. If it will not t the receptacle, have a proper
receptacle installed by a qualied electrician. DO NOT use
any type of adapter with this product.