Use and Care Manual

15
9. Press RESET button (C). The indicator light (D) should be ON.
NOTICE DO NOT use the electric pressure washer if above test
fails.
10. Press the master ON/OFF switch (A) to the Pressure Washer
ON ( | ) position.
11. Point gun in a safe direction, open trigger lock small lever
and squeeze trigger. The electric pressure washer motor will
start and stop as spray gun trigger is depressed and released.
The electric pressure washer is now ready for use. Instructions
for use of the supplied accessories are given later in this section.
How to Stop Your Electric Pressure Washer
The electric pressure washer motor runs only when the trigger is
engaged. To stop the electric pressure washer and turn o the motor:
1. Release spray gun trigger.
2. Turn the master ON/OFF switch to the OFF (O) position.
NOTICE Releasing the trigger will shut o the motor but does
not shut o electrical power to the unit.
3. Turn o water supply.
4. ALWAYS point spray gun in a safe direction and squeeze spray
gun trigger to relieve built up pressure in the unit.
WARNING The high pressure stream of water that this
equipment produces could cut through skin and
its underlying tissues, resulting in serious injury
and possible amputation.
Spray gun traps high water pressure, even when motor is
stopped and water is disconnected, which could result in
serious injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, squeeze spray
gun trigger to release high pressure, every time you turn
o pressure washer.
• To ensure appliance safety, use only spare parts from the
manufacturer or approved by the manufacturer.
• WARNING: High pressure hoses, llings and couplings are
important for the safety of the appliance. Use only hoses,
ttings and couplings recommended by the manufacturer.
• Do not use the appliance if a supply cord or important parts
of the appliance are damaged, e.g. Safety devices, high
pressure hoses, trigger gun..
5. Disconnect GFCI plug from outlet and coil power cord.
6. Coil and store power cord, high pressure hose, spray gun and
accessories on the accessory tray.
Spray Tips
There are four spray tips supplied with the pressure washer.
The soap tip is for general soap applications, and the high
pressure tip is for various high pressure applications.
Black Foam nozzle . Low Pressure Foamer . Use to
apply detergent
White nozzle 40°. Cars / Vans / Trucks / Outdoor
Furniture
General Rinse Yellow, 15° Siding / Patios Decks /
Driveways / Garage Floors
Red nozzle 0°, Removal / Oil Stains / Rust Removal
Usage Tips
• For most eective cleaning, keep spray tips 8 - 24 inches away
from cleaning surface.
• If spray tips get too close, especially using a high pressure spray
trip, you may damage surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent
WARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in
death or serious injury.
• Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
chemicals.
• DO NOT substitute safety glasses or dry-condition goggles
for indirect vented safety goggles.
• DO NOT use caustic liquid with electric pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
• This appliance has be designed for use with cleaning agents
supplied or recommended by the manufacturer. The use of
any other cleaning agents or chemicals may adversely aect
the safety of the appliance.
1. Place the end of chemical hose (N) with lter on it into the
container holding chemical/cleaning solution (O).
2. NOTE: Prepare detergent solution as required by job. Install
lowpressure (black) nozzle into quick connect tting of spray
wand.
NOTE: Chemicals and soaps will not siphon if the black soap
nozzle is not installed on the spray wand.
NOTICE Detergent cannot be applied with high pressure spray
tips.