Manual

English

12.

If the engine is cold, move the choke (L) to the CLOSED position

as shown.

OFF

FIG. 13 FIG. 14 FIG. 15

13. WARNING: Risk of unsafe operation. Pull starter grip slowly

until resistance is felt. Then pull starter grip (I) rapidly to avoid

kickback and prevent hand or arm injury.

NOTE: Do not allow the starter grip to snap back. Return it gently by

hand.

WARNING: Risk of unsafe operation. If engine does not start after

two pulls, squeeze trigger of gun to relieve pump pressure. Pull starter

cord slowly until resistance is felt. Then pull cord rapidly to avoid

kickback and prevent hand or arm injury.

NOTE: If the oil level in the engine is low, the engine will not start. If

the engine does not start, check the oil level and add oil as needed.

14. As the engine warms up, move the choke to the OPEN position.

FIG. 16

FIG. 17

15. Depress trigger on gun to start water flow.

WARNING: Do not allow the unit to run for more than two

minutes without the gun trigger being pulled. This could cause

overheating and damage to the pump. When the temperature

inside the pump rises too high, the thermal relief valve will

open and release a spray of water from the pump to lower the

internal temperature. The valve will then close.

WARNING: Risk of unsafe operation. Stand on a stable surface

and grip gun/wand firmly with both hands. Expect the gun to kickback

when triggered.

16. Release trigger to stop water flow.

DANGER: Risk of injury from spray. Engage the trigger lock (X)

when gun is not in use to prevent accidental spraying.

17. Adjust spray for the task being performed by changing quick

connect nozzle. Refer to Spray Wand Nozzles.

Shutting Down

1. If chemicals were applied, place the chemical hose into a container

of clean water and draw clean water through chemical injection

system to rinse system thoroughly.

NOTICE: Risk of property damage Failure to do so could cause

damage to the pump.

2. Place the engine ON/OFF switch (H) to the OFF Position.

3. Place the fuel valve lever (M) in the OFF position.

OFF

FIG. 18

FIG. 19