Full Product Manual

11
ENGLISH
Nozzle Functionality and Uses
Foaming Nozzle (Black)
• Visibly marks treated weeds when
used with weed killer or added
surfactant.
• Spot spraying weeds in lawn, or
around ower beds, trees, and shrubs.
• Edging along fences, driveways, and
walkways.
High-Volume Wide Fan Nozzle (Brown)
• Flat spray for very broad coverage and
higher viscosity liquids.
Low-Volume Wide Fan Nozzle (Red)
• Replacing lawns. Kills lawn and weeds
before planting a new lawn.
• Preparing large areas for planting of
ornamental and vegetable gardens.
Low-Volume Narrow Fan Nozzle (Yellow)
• Precision spraying in conned areas
such as gardens and ower beds.
Jet Stream Nozzle (Orange)
• Pinpoint stream for targeted
applications from a distance.
• Ideal for spraying sots, cracks,
crevices, and other hard to reach
targets.
Adjustable Cone Nozzle
• Spot spraying in ower beds,
walkways, driveways, and patios,
around trees and shrubs.
• Edging along fences, driveways, and
walkways.
• Killing brush such as poison ivy, poison
oak, kudzu, and wild blackberry.
ASSEMBLY
WARNING: RISK OF PERSONAL INJURY AND/OR
PROPERTY DAMAGE DUE TO CHEMICAL EXPOSURE. After
initial assembly, always inspect the sprayer for damage,
and test it with plain water to check for proper function.
Ensure all connections are secure and leak free, and the
hose is free from damage, prior to using the sprayer with
chemicals.
WARNING: Only use attachments recommended or sold
by the manufacturer.
Flow Control
Flow can be controlled by turning the control knob(1).
The backpack functions to keep ow rate constant
regardless of battery depletion state; when a preferred
knob setting is chosen for a given nozzle, the spray
pattern and ow rate will remain the same through the
entire application.
Flow Control Chart (GPM)
Position Flow
1–3
1–3 work o a low pressure cuto
4–10
4–10 work o a high pressure cuto
N/A*
Spray pattern not recommended for typical use
N/A**
Overworking of pump may occur
Fig. 3
1
Nozzle Flow Rate Chart:
NOTICE: RISK OF PROPERTY DAMAGE. Always turn
flow control knob to low GPM setting (1–3) when
switching to a low flow nozzle.
NOTICE: RISK OF PROPERTY DAMAGE. Failure to
abide by Nozzle Flow Chart recommendations may
result in a damaged pump and void warranty.
See Nozzle Flow Chart on page 18.