Full Product Manual

DXST10000

ASSEMBLY

EXPANDABLE UPRIGHT FRAME INSTRUCTIONS

• Note: For ease of assembly, two (2) Vertical Beams feature

pre-bolted horizontal and diagonal beams.

STEP 1

• Place one (1) Vertical Beam and one (1) Pre-Bolted Vertical

Beam on the floor, parallel to one another (about 24”/60.9 cm

apart). The widest part of the teardrop-shaped hole pattern

on each beam should be facing upward (or away from you).

STEP 2

• Take the free end of the diagonal beam and insert it into

the free end of the top horizontal beam. Align the holes.

Insert both beams into the U-shaped bracket at the top of

the opposing Vertical Beam, and align the holes. Using the

included hex key or hex bit, thread a vertical assembly bolt

through the holes and into the weld nut that is attached to

the U-shaped bracket. Do not fully tighten the bolt.

STEP 3

• Swing out the bottom horizontal beam, and insert it into the

U-shaped bracket at the bottom of the opposing Vertical

Beam. Thread a vertical assembly bolt through the holes and

into the weld nut that is attached to the U-shaped bracket.

Do not fully tighten the bolt.

STEP 4

• Repeat Steps 1-3 to assemble the second upright frame.

Once both are assembled, fully tighten the bolts on all

four corners. Be careful not to over-tighten the bolts; there

should be no deformation of the U-shaped brackets and/or

horizontal beams.

(61 cm)

2 ft

TOP HORIZONTAL BEAM

BOTTOM HORIZONTAL BEAM

DIAGONAL

BEAM

(60.9 CM)