Instructions / Assembly

DXST4500-W

ASSEMBLY

• Note: There are two (2) Safety Straps with Weld Nuts and

three (3) Shelf Support Straps for every set of crossbeams.

STEP 1

• Starting with the lowest set of crossbeams, place a Safety

Strap with Weld Nut between the lower ridges of the

crossbeams where two sets of holes have been pre-drilled.

Thread a Safety Strap Bolt up through the bottom of the pre-

drilled holes and through the weld nuts, and fully tighten with

the included hex key or drill bit. Repeat for the second strap on

this set of crossbeams, and continue for the last four straps.

STEP 2

• Place a Shelf Support Strap perpendicular to the

crossbeams, and insert each end into the slots on each ridge

of the crossbeam. Repeat for the remaining eight straps.

SAFETY STRAP AND SHELF SUPPORT STRAP INSTRUCTIONS

SHELF SUPPORT

STRAPS

SAFETY STRAP

WITH WELD NUT