Warranty

8
DXSTFB048
ASSEMBLY
CROSSBEAM INSTRUCTIONS
• Note: It is recommended for one person to hold the
pre-assembled upright frames in place while a second person
installs the crossbeams.
• Note: Keep the bolt heads of the diagonal pieces of the uprights
on the outside of the assembly (*see first image).
• Note: The top crossbeams have 4 slots for their associated
bench support straps, and the bottom crossbeams have 3
slots for their associated support straps.
STEP 1
• There is a set of locking tabs at both ends of every crossbeam.
To begin assembly, take a crossbeam with 3 slots and insert
the tabs into two of the holes on the lower portion of one
upright frame. Engage the locking tabs into the holes using
a downward motion. The locking bolt hole should be at the
top. Make sure the end of the crossbeam is flush against the
upright frame.
STEP 2
• Repeat for the opposite side of the upright frame. Tap the ends
of the crossbeam closest to the upright frames with a rubber
mallet until fully seated. The crossbeam and locking tabs
should easily slip into place. If they do not, then recheck the
alignment of the teardrop-shaped holes and tabs. Too much
force may damage the interlock between the crossbeam and
upright frame.
STEP 3
• Using the methods listed above, install the other crossbeam
with 3 slots to the opposite side of the upright frames,
parallel to the first crossbeam you installed. Make sure both
crossbeams are at the same level.
STEP 4
• Continue by installing the top sets of crossbeams flush to the
top of the upright frames (each top crossbeam has 4 slots and
one will have the DEWA LT
®
badge on the far right). Make sure
the crossbeams are attached at the same level on both sides.
LOCKING
PIN HOLE
UPRIGHT
FRAME
*KEEP BOLT
HEADS OF
DIAGONAL
PIECE ON
OUTSIDE OF
ASSEMBLY