User's Manual

OKIMAT 8 Installation
69596(c) 15
6.2 Installation procedure
6.2.1 An example installation
Before installing the drive, make sure that you are observing all of the safety notices found in the
"Safety notices to observe during installation" section.
1 Move your product into a position where it is supporting no load.
CAUTION
Danger of crushing injury!
•
Be sure to carry out work on the drive in a position so that no loads are bearing on it. Only in
this way can you be sure to avoid any risks of crushing or injury.
• Disconnect the nine-volt battery if you are using the battery-operated reset function.
2 Pull the shutters firmly to the side (A). The slots (B) for the brackets (D) are now uncovered.
Figure 6 Installing the double drive
A
Shutters
B
Fitting mounts
3 Align the OKIMAT 8 next to your product. The slots for the back and leg sides must be properly
aligned with the correct brackets on your end product (refer to the symbols on the OKIMAT 8 as
described in Figure 3).
Figure 7 Installing the double drive
C End product (bed)
D Brackets
B
B
A
A
C
D
D