User's Manual

Installation OKIMAT 8
16 69596(c)
Figure 8 Installing the double drive
4 Push the drive in so that the brackets (D) fit into the slots (B). Press in until the tubes snap into
the brackets.
5 Close the shutters (A) on the drive by snapping them back in. The OKIMAT 8 is now securely
attached to the end product.
6 Disconnect all additional components (handset, etc.) from their sockets.
7 Now connect the drive to the power supply.
Please note, after the power supply has been connected:
 There is a delay after the supply voltage is applied before the device actually turns on. Wait at
least two seconds before beginning the commissioning.
6.2.2 Electrical connection
CAUTION
Risk of accident
Electrical components should be connected or disconnected only when the power supply cord is
unplugged.
Only the following personnel are qualified to work on the power cord or to replace the power cord:
• someone who has completed training in electronic motor assembly,
• someone with equivalent qualifications, or
• someone who has successfully completed the appropriate DewertOkin training program.
You should only work on the power cord when you are qualified to do so. Otherwise, a properly
qualified person should be found for this task.
 There is a delay after the supply voltage is applied before the device actually turns on. Wait at
least two seconds before beginning the commissioning.