User's Manual

Table Of Contents

Installation OKIMAT 8

18 69596(c)

Optional: battery-operated reset function

Connecting the nine-volt batteries

Figure 10 Connecting the 9-V battery/batteries

A Battery clip connected, B Battery clip, unattached

C 9-V battery (type 6LR61)

 Connect the nine-volt batteries first when you would like to perform a battery-operated reset.

The batteries may only be used to power the reset function one time. Take out the batteries and

dispose of them properly after the reset function has been carried out.

Routing the electrical cables

When routing the cables, be sure that:

• the cables cannot get jammed,

• no mechanical load (such as pulling, pushing or bending) will be put on the cables, and

• the cables cannot be damaged in any way.

Fasten all cables (especially the mains cable) to the end product using sufficient strain relief and

kink prevention methods. Be sure that the design of the end product prevents the mains cable from

coming into contact with the floor during transport.