User's Manual

OKIMAT 8 Installation
69596(c) 19
6.2.3 Dismantling
CAUTION
Risk of accident
• Work on electrical components should be conducted only when the mains power connection
is unplugged.
• Disconnect the nine-volt battery if you are using the battery-operated reset function. ..
 Certain details may change because of technical changes.
Figure 11 Removing the double drive
1 Move your product into a position where it is supporting no load.
CAUTION
Danger of crushing injury!
Be sure to carry out the removal work on the drive in a position so that no loads are bearing on
it. Only in this way can you be sure to avoid any risks of crushing or injury.
2 Disconnect the OKIMAT 8 from the power supply!
3 Disconnect all additional components such as slave drives or handset from their sockets.
 Be sure to support the drive's weight to prevent it from falling.
4 Open the optional snap-in locks on the cover (A) until they snap in.
5 Pull the shutters firmly to the side (A).