User's Manual

OKIMAT 8 Information about creating your Operating Manual
69596(c) 23
7.2 Notice for operating with optional configuration
7.2.1 Optional: battery-operated reset function
The battery-operated reset function allows the drive system to be operated during a power outage.
One or two 9-V batteries can be used to power the OKIMAT 8 in the event of a power outage. The
batteries should be connected only then when the outage occurs. The batteries are not connected
by default since they have very limited capacity. They can only be used to power the reset function
once. The used batteries should then be replaced and properly disposed of.
NOTICE
The battery-operated reset function is not a safety system and does not avert danger.
When working with radio units (RF), first disconnect the drive system from the power supply! Con-
nect the nine-volt battery first when you would like to perform a battery-operated reset. The battery
may only be used to power the reset function one time. Take out the battery and dispose of it prop-
erly after the reset function has been carried out.
NOTICE
Connect the nine-volt batteries first when you would like to perform a battery-operated reset. The
batteries may only be used to power the reset function one time. Take out the batteries and dis-
pose of them properly after the reset function has been carried out.
NOTICE
When using the electrical reset function, make sure that the entire movement is executed without
interruptions.
 If the end product is under a heavy load which prevents the reset function from operating, the
strain or load on the end product must first be removed before a reset can be carried out.