User's Manual

Safety notices OKIMAT 8
8 69596(c)
Optional: battery-operated reset function
NOTICE
The battery-operated reset function is not a safety system and does not avert danger.
DewertOkin does not guarantee that the drive will function in the event of a power outage.
If the end-product manufacturer chooses to guarantee the functionality of the end product during a
power outage, then the end-product manufacturer is responsible for arranging a mechanism to en-
sure this functionality.
2.2 Selection and qualification of personnel
The installation of the drive in the end product may only be performed by qualified personnel.
2.3 Notice on safety during operations
Basic safety rules must be followed in order to ensure that the end product can be continually op-
erated in a safe manner. These rules must be observed while using the end product and while in-
stalling the drive.
These rules and safety measures can be categorized as follows:
• Construction measures before the installation (refer to the "Safety notices to observe during in-
stallation" section in Chapter "Installation").
• Safety fundamentals during the drive installation and during cable and wire routing (refer to the
"Safety notices to observe during installation" section in the "Installation" chapter).
• Using the drive in intermittent duty (refer to the "General information" section in the "Information
about creating your Operating Manual" chapter).
• Basic safety rules during operation (refer to the "Information about creating your Operating
Manual" Chapter).
• The creation of a manual for the end product which contains these and other safety rules.
Creating a user's manual
The manufacturer of the end product must create a manual for the users of that product. The safety
notices in the end-product manual must be written based on the end product's risk assessment.