User's Manual

Caution: Investigational device. Limited by Federal (United States) law to investigational use.

CONFIDENTIAL Page 1 of 3



Under FDA Review

™ STS™ C

ONTINUOUS

LUCOSE

ONITORING

YSTEM

SER

UIDE

RANSMITTER

ODEL

UMBER

9300 & R

ECEIVER

ODEL

UMBER

8204

Starting Continuous Glucose Monitoring

Choose a site on your abdomen (belly) to put the Sensor that is a flat area and where you don’t have any scarring or rough patches

of skin and clean the site with an alcohol swab. Remove the adhesive backing from the STS™ Sensor Pod and place the STS™

Sensor on the selected site.

1. Pull the safety lock out from the Applicator.

2. Place 2 fingers under the collar, with your thumb on the plunger, and push the plunger down completely.

3. At the same time that you are pushing the plunger down, pull the collar back completely until you hear a click.

4. Press the tabs on the sides of the STS™ Sensor Pod and pull out the STS™ Applicator.

TEP

1- Inserting a New STS™ Sensor

Push plunger

Remove STS™ Applicator

STS™ Sensor Pod remains adhered

Press tabs

Collar completely back

Safety Lock

Pull Collar

STS™ Sensor & STS™ Applicator

STS

™

Sensor &

STS™ Transmitter

STS™ Receiver

PAGE 1
Under FDA Review DEXCOM™ STS™ CONTINUOUS GLUCOSE MONITORING SYSTEM USER GUIDE FOR TRANSMITTER MODEL NUMBER 9300 & RECEIVER MODEL NUMBER 8204 STS™ Sensor & STS™ Transmitter STS™ Sensor & STS™ Applicator STS™ Receiver Starting Continuous Glucose Monitoring STEP 1- Inserting a New STS™ Sensor Choose a site on your abdomen (belly) to put the Sensor that is a flat area and where you don’t have any scarring or rough patches of skin and clean the site with an alcohol swab.
PAGE 2
Under FDA Review STEP 2- Installing Your STS™ Transmitter Place the STS™ Transmitter into the STS™ Sensor Pod with the flat side facing down. Pull the STS™ Transmitter Latch up onto the to STS™ Transmitter to snap it into place. Remove the STS™ Transmitter Latch by holding the end of the latch and quickly twisting off the latch away from your body.
PAGE 3
Under FDA Review If the Calibration Update Screen or the Out of Calibration Screen appears on the STS™ Receiver, clear the prompt, take a BG fingerstick to bring the STS™ System back into calibration. When the STS™ Sensor glucose value is above or below the alert settings you have selected (factory settings are 80 and 200), the STS™ Receiver will notify you of a high or low glucose value. Press any button on the STS™ Receiver to acknowledge the alert.