User Manual

11
Before You Start to Play
4
Connecting the AC Adaptor
1. Rotate the [VOLUME] the knob toward the left position to
minimize the volume.
2. Connect the included power cord to the AC adapter.
The indicator will light once you plug the AC adaptor into a wall
outlet.
Power cord
AC Adapter
To an AC outlet
NOTE
Depending on your area, the included power cord may dier
from the one shown above.
NOTE
Be sure to use only the AC adaptor (DEXIBELL DYS602-240250W)
supplied with the unit. Also, make sure the line voltage at the
installation matches the input voltage specied on the AC
adapter body. Other AC adapters may use a dierent polarity, or
be designed for a dierent voltage, so their use could result in
damage, malfunction, or electric shock.
NOTE
If you won’t be using the VIVO S7/S3 for an extended period of
time, disconnect the power cord from the electrical outlet.
NOTE
To avoid malfunctions, never disconnect the AC/DC adapter
while the instrument is turned on.
3. Connect the AC adaptor to VIVO S7/S3’s DC IN jack
positioned to the rear bottom panel.
Installing Music Rest
Install the included music rest as shown in the illustration below.
Ground Terminal
Depending on the circumstances of a particular setup, you could
feel a tingling sensation at the point where touch this device.
You can eliminate this sensation connecting the ground terminal
with an external ground.
VIVO S7/S3 REAR SIDE
1. Use the screw-type ground terminal to connect to ground
or to connect to the chassis of the mixer, preamp, or other
device in your system.
Turning the Power On/Off
Once everything is properly connected, be sure to follow the
procedure below to turn on their power.
1. Rotate the [VOLUME] the knob toward the left position to
minimize the volume.
NOTE
Before turning the VIVO S7/S3 on/o, always be sure to turn the
volume down. Even with the volume turned down, you might
hear some sound when switching the VIVO S7/S3 on/o.
However, this is normal and does not indicate a malfunction.
2. Press the VIVO S7/S3’s [ " ] button located on the right
panel to switch it on.