RF WIRELESS SCROLL MOUSE USER’S MANUAL Model #: MW1083 1
Important Ergonomic Information Some experts believe that using any mouse or trackball may cause serious injury to hands, wrists, arms, neck, or back. If you feel pain, numbness, or weakness in these areas, see a qualified health professional. TO REDUCE THE RISK OF INJURY, FOLLOW THESE PRECAUTIONS: z z z z z Take frequent breaks, Get up and walk around several times every hour. Vary your tasks throughout the day. Keep your shoulders relaxed with your elbows at your side.
Precaution ! Notebook computer is not recommended. This RF wireless mouse is designed to use with desktop computer. PS2 ports of different notebooks have different data format. Some of them might not fully compatible with this RF wireless mouse. Hence, we highly recommend using this RF wireless mouse with desktop computer.
ID channels for both receiver and mouse. Please follow the steps as below to set up: 1. Turn to the bottom of the receiver and you will see a small rectangular hole (take the cover as Fig-2.1) and a slide switch (channel selection, Fig-2.1 refer to Fig-2.2). 2. The carrier channel is set by a slide switch with A or B positions. Make sure the switches have the same setting as the mouse, as following descriptions (refer the right Fig-2.3, it is pre-set at factory). 3.
Battery Warning! When replace the batteries, use alkaline. You may use other heavy-duty NiMH batteries, but do not mix then with alkaline. Do not mix used and new batteries together! Step 4.Installing the Software To install the software, please follow the steps below to finish: If the package contains a floppy disk 1. Insert the floppy disk into floppy driver, then type "A:\setup" from RUN, START, Click OK or press ENTER. 2. Choose the Pilot Mouse Wireless Scroll 3.
GENERAL SPECIFICATIONS z z z z z z Digital Radio Frequency wireless mouse with receiver 2 channels and 256 ID selections for your options to prevent interruption. 4 buttons design for multimedia purpose to immediately play video/audio sources or get into Internet with a single click The Second, Third and Fourth buttons assignment Ergonomic design for comfortable grip Electromagnetic Characteristics (EMC) FCC ID: NIYMW1083 This unit complies with Part 15 of FCC Rules.
z z z z Operating Voltage: Transmitter: 1.8 to 3.2V DC (powered by batteries) Receiver: 4.5 to 5.5V DC (powered by PS/2 port) Operating Current: Transmitter: 11mA Receiver: 30mA typical Standby Current: Transmitter: 0.2mA or lower FSK transmission, 4K transmission rate with one way error detection Troubleshooting 1. Mouse does not function If mouse is not functional, please turn off the computer first. Check the cable is firmly attached to the computer mouse port.
environment. If the effective distance between the mouse and the receiver is bad, try to change the location of the receiver. 4. If you have difficulty connecting the wireless mouse: Increase the distance between the set of wireless mouse and other radio device units. Turn off the other wireless devices, or their base units, that are in close proximity to the receiver of this wireless mouse. Try connecting the wireless mouse and its receiver again.