User's Manual
Table Of Contents
- 2.4GHz Wireless Optical Mouse
- System Requirements
- Before you begin
- When battery power becomes low, battery indicator LED on the top of the mouse will blink when moving or clicking the mouse. The mouse will continue to operate for a period of time depending on usage, but batteries should be replaced immediately.
Package Contains
Your DC177-P6S Mouse package includes the following:
1. The wireless optical mouse
2. USB RX36_6S receiver
3. User’s manual
4. 2 AAA alkaline batteries
Note：If any part is missing, please contact your dealer for a replacement immediately.
Precaution
The optical mouse can not work on a glass or mirror surface. Avoid operating this mouse
on a glossy surface; otherwise, this mouse may not operate normally.
For conservation of battery power, it is strongly recommended to operate an optical
mouse on a bright surface with fine texture to obtain lower power consumption of the high
illumination LED. A very dark surface will cause higher power consumption.
For optimal performance, mouse should be no more than 5M away from receiver.
For a better transmission distance, avoid using this device on a metal plate or desktop
because a large surface of iron, aluminum, copper and other metal will act as a shield or
ground to the RF antenna of the mouse and receiver. Operating on a metal surface may
shorten the transmission distance.
If your notebook computer has a metal (contains Al or Mg) case, the metal housing of
the LCD panel will isolate partial radiation of the RF signal from the mouse. This could
possibly result in reducing the distance of transmission when you operate the mouse right in
front of the notebook and when the receiver is connected on the back of the notebook.
However, the RF mouse should work properly while you are operating the mouse just beside
your desktop computer.
DC177-P6S 2.4GHz Wireless Optical Mouse Page 2 of 7 1.0 Edition