User's Manual

Step 2. Synchronize the RF Mouse
If the mouse is in sleep mode click the mouse button once to wake it up.
1. Plug the receiver into the notebook Computer’s USB ports or into the
keyboard’s USB port.
2. Bring the mouse within 1 ft range from the receiver, Hold the mouse
upside-down and use a pointed object, such as a pen tip, to click the
“CONNECT” button once. Do Not depress the CONNECT button longer then
1.5 seconds. (The red sensor light will go off when the “CONNECT” button is
pressed down.)
! Please poke the Mouse Connect button first, and then click the receiver’s
button!
2. Click
3. Click
1. Plug into
USB Port
3. Click the receiver’s connect button once (located on the back of the receiver)
within 5 seconds of clicking the connect button on the mouse. The LED will
start blinking, when the connection is established.
4. Move the mouse around to test if it was successful.
5. If the synchronization is not successful for some reason please (1) Remove the
batteries and unplug the receivers (2) Wait for 20 sec then to try the step 1 to 4
again.
Note: * During normal use, please make sure that the mouse is no more than 3 ft
away from the receiver in order to have reliable connection.
** The LED on the receiver will light up or blink while the mouse is being
used.
Operation Guide
Battery low indication
When the voltage level of the battery goes down under the preset level, the scrolling
wheel will flash at least three times on moving or clicking the mouse. Although the
mouse can still work for a while, the user, at this time, should have a new set of
3