User's Manual

batteries ready for replacement. Or, if the user has a companion charger base, and
Two re-chargeable batteries are inside the mouse, charge the mouse as soon as
possible.
Power off the mouse
1. Be sure the mouse is NOT in sleep mode. If it is, press any key to wake it up.
2. Press and hold the Connect button on the bottom of the mouse for more than 2
seconds. (The red light will go off while the Connect button is depressed.)
3. Wait until the red light flash once. Release the Connect button.
4. Now, the mouse is in power off mode. No operation can be done.
Power on the mouse
To activate the mouse again, press the Connect button on the bottom of the mouse
once. (DO NOT depress the Connect button for more than 1.5 seconds when
resuming the mouse from power off mode.) The red light will turn on, and the mouse
is ready for normal operation.
Note: Be sure to press the connect button firmly in procedure, if the connect button is not
depressed steadily the red light will be on before 2 seconds expire. This will result in a
change of channel and ID. Don’t panic, just re-connect the mouse to the receiver, and
follow step 4 again.
Operations on power saving mode
In order to conserve battery power, the mouse is designed to reduce power
consumption gradually from standby mode to sleep mode, if it is not being used.
Standby mode – Around 2 seconds after the mouse stops moving, it enter into
standby mode.
Sleep mode – If the mouse is left intact for around 8 minutes, it goes to sleep mode
and shuts down the optical sensor to maintain minimum power consumption. No
moving operation is possible in this mode.
Wake up the mouse
This mouse can work promptly under Standby mode so users might not be able to tell
the existence of this mode. But, in sleep mode, users have to press any button to
wake up the mouse for normal operation.
4