User's Manual

Step 2. Synchronize the RF Mouse
1. Bring the mouse within 1 ft range from the receiver, Hold the mouse
upside-down and use a pointed object, such as a pen tip, to click the
“CONNECT” button once. Do Not depress the CONNECT button longer then
1.5 seconds. (The red sensor light will go off when the “CONNECT” button is
pressed down.)
! Please poke the Mouse Connect button first, and then click the receiver’s
button!
2. Click the receiver’s connect button once (located on the back of the receiver)
the LED will start blinking, when the connection is established.
Click
3. Move the mouse around on the desk, the mouse cursor should be moving and
the mouse is ready to use.
4. If the synchronization is not successful for some reason, please (1) Remove
the batteries and unplug the receivers (2) Wait for 20 sec then try the steps 1 to
3 again.
4