User's Manual

! Please poke the mouse Connect button first, and then click the receiver’s button!
4
2. Click the receiver’s Connect button
once (located on the front of the charger.) The red LED beneath the Connect
button will start blinking, when the connection is established.
Click
3. Move the mouse around on
the desk, the mouse cursor should move accordingly. Now the mouse is ready
to use.
Click
4. If the synchronization is not successful for some reason, please (1) remove the
batteries and unplug the receivers, (2) wait for 20 sec then re-install the
batteries and re-plug the receiver to your system. Try the steps 1 to 4 again.
Note: * During normal use, please make sure that the mouse is no more than 3 ft
away from the receiver in order to have reliable connection.
** The LED on the receiver will light up or blink while the mouse is being