Operator`s manual

ManualsBrandsDexter Laundry ManualsDryerDDAD50KC Series

8514-141-001

The dryer must not be stored or installed where it will be exposed to water and/or weather.

OPERATOR’S MANUAL

for

DDAD50KC Series Dryers

manufactured by

Dexter Laundry Inc.

2211 W. Grimes

Fairfield, Iowa 52556

WARNING: For your safety the infor-

mation in this manual must be fol-

lowed to minimize the risk of fire or

explosion or to prevent property dam-

age, personal injury or loss of life.

Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any other

appliance.

– WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in your building.

• Clear the room, building or area of all

occupants.

• Immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions.

• If you cannot reach your gas supplier,

call the fire department.

– Installation and service must be performed by

a qualified installer, service agency or the

gas supplier.

You, the purchaser, must post in a prominent loca-

tion instructions to be followed in the event the user

smells gas. Consult your local gas supplier for

procedure to be followed if the odor of gas is

present.

Post the following “For Your Safety” caution in a

prominent location:

FOR YOUR SAFETY

Do not store or use gasoline or other flammable

vapors or liquids in the vicinity of this or any other

appliance.

It is important that you read this Manual and retain it for

future reference. For service or replacement parts,

contact the distributor in your area or the manufacturer.

AVERTISSEMENT. Assurez-vouz de

bien suivre les instructions données

dans cette notice pour réduire au

minimum le risque d'incendie ou

d'explosion ou pour éviter tout

dommage matérial, toute blessure

ou la mort.

Ne pas entreposer ni utiliser d'essence ni d'autres

vapeurs ou liquides inflammables dans le voisinage

de cet appareil ou de tout autre appareil.

– QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE

GAZ:

• Ne pas tenter d'allumer d'appareil.

• Ne touchez à aucun interrupteur. Ne pas

vous servir des téléphones se trouvant

dans le bâtiment où vous vous trouvez.

• Évacuez la pièce, le bâtiment ou la zone.

• Appelez immédiatement votre

fournisseour de gaz depuis un voisin.

Suivez les instructions du fournisseur.

• Si vous ne pouvez rejoindre le fournisseur

de gaz, appelez le service des incendies.

– L'installation et l'entretien doivent être assurés par

un installateur ou un service d'entretien qualifié ou

par le fournisseur de gaz.

POUR VOTRE SÉCURITÉ

Ne pas enteposer ni utiliser d'essence ni d'autres

vapeurs ou liquides inflammables dans le voisinage

de cet appareil ou de tout autre appareil.

Summary of content (14 pages)

PAGE 1
8514-141-001 OPERATOR’S MANUAL for DDAD50KC Series Dryers The dryer must not be stored or installed where it will be exposed to water and/or weather. WARNING: For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance.
PAGE 2
TABLE OF CONTENTS Page No. Warnings about use and operation .................................................................................... 2 Installation and Operating Instructions ...................................................................... 4, 5, 6 Dryer Shutdown ................................................................................................................. 8 Description of Controls ...........................................................................................
PAGE 3
51 8" VENT 4 3/4 6 7/8 GAS INLET ELECTRICAL CONNECTIONS 86 1/4 79 3/8 34 1/2 DDAD50 STACKED DRYER
PAGE 4
INSTALLATION AND OPERATING INSTRUCTIONS UNCRATING AND PLACING DRYER Tools Required: 3/4" hex socket & ratchet driver, wood block 4" or 5" thick, a knife and a groove joint plier which will open to 1 3/8". 1. Remove and discard packaging. 2. The crate base is attached to the dryer by (4) cap screws driven upward from below the crate base. Remove crate base from dryer, by tipping dryer sidewise and place block under crate base rail in center of dryer.
PAGE 5
The sources of all make-up air and room ventilation air movement to all dryers must be located away from any dry cleaners. This is necessary so that solvent vapors will not be drawn into the dryer inlet ducts. Dry cleaner solvent vapors will decompose in contact with open flame such as the gas flame present in clothes dryers. The decomposition products are highly corrosive and will cause damage to the dryer(s) ducts and clothes loads. 4. ELECTRICAL REQUIREMENTS.
PAGE 6
CAUTION: The dryer and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig. The dryer must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig. 6. EXHAUST INSTALLATION. (Refer to Figure 3 at the end of section 6.
PAGE 7
PAGE 8
7. DRYER IGNITION (SOLID STATE IGNITION): The solid state ignition system lights the main burner gas by spark. The gas is ignited and burns only when the gas-relay (in the electronic controller) calls for heat. The procedure for first-time starting of a dryer is as follows. A. First review and comply with the "Warnings About Use and Operation" found on the inside front cover of this manual. Be sure electrical power is connected correctly. The dryer must be properly grounded. B.
PAGE 9
OPERATING INSTRUCTIONS 1. Load clothes into either the upper or lower drum (or both). Close the door(s) completely. 2. Deposit coin or coins equal to or greater than the displayed vend price. Upon deposit of the first coin, the green light will flash on and off. This light will continue to flash, while additional money may be deposited, until either the upper drum or lower drum is selected. 3. Select drying temperature by pressing the appropriate switch for the drum to be used.
PAGE 10
The controller is put into the programming mode by opening both dryer doors and actuation of a switch on the controller circuit board and remains in this mode until one of these actions occur: 1. The switch is actuated again. 2. The seventeenth step is completed and the step switch is pushed following the seventeenth step. 3. Programming is stopped for about one minute. 4. The dryer doors are closed.
PAGE 11
PAGE 12
SERVICING DRYER CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. ATTENTION. Lors des opérations d'entretien des commandes, étiqueter tous les fils avant de les déconnecter. Toute erreur de câblage peut être une source de danger et de panne. DRYER PREVENTIVE MAINTENANCE (PM) REQUIREMENTS MAKE SURE ALL POWER IS DISCONNECTED BEFORE SERVICING MACHINE DAILY 1.
PAGE 13
Instructions - Convert a Dual Voltage Stack Dryer from 120V to 208-240V with Neutral Wire Only 1. Remove incoming power from the dryer. Use a known working voltmeter to check power. 2. Remove the cover of the control box assembly from the dryer using a 5/16” wrench. 3. Move the black/blue wire from the N position of the main power terminal block to the L2 position of the main power terminal block in the control box assembly. See Figure 1 below. 4.
PAGE 14
Contact Information: Address: Dexter Laundry Inc. 2211 W. Grimes Ave. Fairfield, IA 52556 Phone: 1-800-524-2954 Website: www.dexterlaundry.