P/N 8514-196-001PR MODEL T1200 80 LB CAPACITY COMPUTER CONTROL OPL WASHER DEXTER LAUNDRY, INC.
Please read this information and retain for reference. WARNING - THIS WASHER IS EQUIPPED WITH DEVICES AND FEATURES RELATING TO ITS SAFE OPERATION. TO AVOID INJURY OR ELECTRICAL SHOCK, DO NOT PERFORM ANY SERVICING UNLESS QUALIFIED TO DO SO. IT IS THE RESPONSIBILITY OF THE OWNER TO CHECK THIS EQUIPMENT ON A FREQUENT BASIS TO ASSURE ITS SAFE OPERATION. A machine should not be allowed to operate if any of the following occur: • • • • Excessively high water level.
INSTALLATION INSTRUCTIONS All washers must be installed in accordance with all local, state, and national building, electrical, plumbing and other codes in effect. WARNING - THESE INSTALLATION AND SERVICING INSTRUCTIONS ARE FOR USE BY QUALIFIED PERSONNEL ONLY. TO AVOID INJURY AND ELECTRIC SHOCK, DO NOT PERFORM ANY SERVICING UNLESS QUALIFIED. FOUNDATION REQUIREMENTS This machine is designed for use on or over bare concrete floor - not to be used above combustible flooring.
FLOOR OUTLINE Figure 1-1 Figure 1-2 Figure 1-3 MACHINE MOUNTING DETAIL CONCRETE PEDESTAL MOUNTING 4
I ND U STR I A L W A S HE R
ELECTRICAL ╔════════════════════════════════════════════════════════════════════╗ ║ WARNING ║ ║ SHUT OFF POWER AND WATER BEFORE OPENING ANY SERVICE PANELS. ║ ╚════════════════════════════════════════════════════════════════════╝ Dexter T1200 washing machines are intended to be permanently installed appliances. The machine should be connected to an individual branch circuit not shared by lighting or other equipment.
CHEMICAL INJECTION Dexter T1200 washing machines are intended to be permanently installed appliances. The machine is intended to have a chemical injection system operating with it. There are convenient electrical connection points for the injection pumps shown in Figure 3. Up to four (4) independent pumps can be controlled through the signals A, B, C and D. The injection pump signals are 24 VAC. The COM shown in Figure 3 is the common or return for these injection signals.
MODEL WCND80HCS-12 CAPACITY 12 CUBIC FEET (UP TO 80 POUNDS) ELECTRICAL 208-240 VAC, 60 HERTZ, 1 PHASE OR 3 PHASE EXTRACTION FORCE 100 G’S WASH SPEED SPIN SPEED 43 R.P.M. 485 R.P.M.
OPERATING CONTROLS There are four (4) switches that control the washer operation. shown below, followed by an explanation of each switch. Each switch is Figure 7 - Push-button Control Switches STOP (RED) Push-button - Depress momentarily. Stops the washer during the cycle. All washer cycle information is retained, the door remains locked, and the water remains in the tub. STOP (RED) Push-button - Depress and hold for 3 seconds or longer. Stops the washer and clears the cycle.
OPERATING INSTRUCTIONS 1. Ensure that power is turned on to the washer. 2. Ensure that the ADVANCE/RUN/PROGRAM key lock is in the RUN position. 3. Load the clothes loosely in the cylinder, and latch the door securely. Be sure clothing does not get caught between the door gasket and tub front when closing the door. NOTE: To begin closing the door, the handle must be in the horizontal position.
END OF CYCLE At the end of the cycle, the machine stops, the END CYCLE LED lights, the alarm sounds, and the loading door unlocks allowing unloading of the machine. SAFETY DOOR LOCK This machine is equipped with a safety door lock, which prevents opening the door if power is interrupted, until it is safe to do so. If power failure occurs, it will be necessary to wait 2 to 3 minutes before the door can be opened.
PROGRAMMING INSTRUCTIONS - EDITING EXISTING CYCLE There are 29 preset wash cycles programmed into the washer at the factory. Although these cycles are common industry cycles, there may be a need to tailor the cycle to meet an exact application. This can easily be done with the following instructions. Note: It is recommended when changes are made to one or more of the preset programs, that the cycle number and the changes be documented for later reference.
Either water level can be selected. 9. Push the green ENTER button. (The water level has now been entered.) The Injection Source LED lights and the Water Level LED is out. The injection source for this segment is displayed. If no change is required, then continue to the next instruction. If a change is required, then use the SCROLL UP/SCROLL DOWN buttons to change the injection source. See the Injection Source Table for proper selection.
Below are two important notes about the diagnostic cycle: • Cycle Terminate - At any time during the diagnostic cycle, depressing and holding the stop button for a minimum of 3 seconds terminates washer activities and clears the cycle. • Injection Signals - The injection signals are not tested during the diagnostic cycle. Cycle 31 Sequence - Short Individual Function Test 1. Close the washer door. 2. Turn the control key to the PROGRAM mode. 3.
• Step 7 - Turn on the hot water to the tub. The pressure switch high level setting of the pressure switch can be tested at this point. The drain valve is closed and hot water on for as long as the START button is pushed. When the water level reaches a high level, the water valve will turn off and no additional hot water can be added. (The time required to reach a high water is dependent on input water pressure. It may require several minutes.) • Step 8 - Turn on the hot water to the dispenser.
will turn off and the hot and the cold water valves to the tub will turn on until the low water level is reached or for 30 seconds, whichever comes first. Then the drain will open and proceed to the next step after the “open drain” step is completed. If advancing before a chemical injection of the bath, the drain will open immediately and the cycle will proceed to the next step when the “open drain” step is completed. If advancing during a spin, the tumbler will begin to decelerate immediately.
OPL 80 POUND WASHER COMPUTER CONTROLLED PRESET CYCLE INFORMATION APPLICATION Shirt/Laundry CYCLE # 1 2 DESCRIPTION Shirts (No Starch) Shirts (Starch) Hotel/Motel 3 4 5 6 7 8 9 10 11 12 White Sheets White Pillowcases White Towels, Bath Mats, Wash Cloths Colored Sheets and Towels Delicate Wash Housekeeping Rags and Mops Housekeeping Uniforms Stain Treatment Reclaim Part 1 Part 2 Health Care 13 14 15 16 17 Sheets and Pillowcases Towels Diapers and Pads Personals Delicate Food & Beverage 18 19 20 21 2
CYCLE 1 Shirt/Laundry Shirts (No Starch) Segment Cycle Time Water Temp Water Level Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final 12 2 2 2 HH CH CH CH LO HI HI HI 4 CH LO Inject Source Spin Time Detergent/Bleach1 3 Total Time: 25 minutes excluding the tub fill time. Notes: 1. Use only oxygen bleach in shirt laundries. DO NOT USE CHLORINE BLEACH.
CYCLE 3 Hotel/Motel White Sheets Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time 7 7 2 2 Water Temp Water Level Inject Source HH HH CH CH LO LO HI HI Detergent Bleach 4 CH LO Sour/Soft Spin Time 1 4 Total Time: 27 minutes excluding the tub fill time.
CYCLE 5 Hotel/Motel White Towels Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 7 1 7 2 2 HH HH HH CH CH LO HI LO HI HI Detergent 4 CH LO Sour/Soft Bleach Spin Time 1 5 Total Time: 29 minutes excluding the tub fill time.
CYCLE 7 Hotel/Motel Delicate Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level 8 2 2 2 CH HH CH CH HI HI HI HI 4 CH LO Inject Source Spin Time Detergent/Bleach Sour/Soft 4 Total Time: 22 minutes excluding the tub fill time.
CYCLE 9 Hotel/Motel Uniforms Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 2 CH HI 7 7 2 2 HH HH CH CH LO LO HI HI Detergent Bleach 4 CH LO Sour/Soft Spin Time 1 4 Total Time: 29 minutes excluding the tub fill time.
CYCLE 11 Hotel/Motel Reclaim (Part 1) Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 20 3 HH HH LO HI Manual 3 HH HI Spin Time 1 Total Time: 27 minutes excluding the tub fill time.
CYCLE 13 Health Care Sheets and Pillowcases Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 3 2 7 7 2 2 CH CH HH HH CH CH HI HI LO LO HI HI Detergent Bleach 4 CH LO Sour/Soft Spin Time 1 4 Total Time: 32 minutes excluding the tub fill time.
CYCLE 15 Health Care Diapers Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time 3 2 2 7 2 7 2 2 4 Water Temp Water Level CH CH CH HH HH HH CH CH CH HI HI HI LO HI LO HI HI LO Inject Source Spin Time Detergent Bleach Sour/Soft 1 4 Total Time: 36 minutes excluding the tub fill time.
CYCLE 17 Health Care Delicate Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level 2 CH HI 7 2 2 2 CH CH CH CH HI HI HI HI 4 CH HI Inject Source Spin Time Detergent/Bleach Sour/Soft 3 Total Time: 22 minutes excluding the tub fill time.
CYCLE 19 Food and Beverage Colored Cotton Linen Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 2 CH HI 10 7 2 2 HH HH CH CH LO LO HI HI Detergent Bleach 4 CH LO Sour/Starch Spin Time 1 4 Total Time: 32 minutes excluding the tub fill time.
CYCLE 21 Food and Beverage Colored 100% Polyester Linen Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 2 CH HI 10 7 2 2 HH HH CH CH LO LO HI HI Detergent Bleach 4 CH LO Sour/Starch Spin Time 1 4 Total Time: 32 minutes excluding the tub fill time.
CYCLE 23 Food and Beverage Kitchen Rags Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 5 2 8 2 7 2 HH HH HH HH HH CH LO HI LO HI LO HI Detergent 2 CH HI Detergent Bleach Spin Time 1 1 5 Total Time: 35 minutes excluding the tub fill time.
CYCLE 25 Food and Beverage White/Colored 100% Polyester Linen Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 2 CH HI 10 1 2 2 2 HH HH HH CH CH LO HI LO HI HI Detergent/Bleach 4 CH LO Sour/Starch Spin Time 4 Total Time: 27 minutes excluding the tub fill time.
CYCLE 27 Food and Beverage Kitchen Rags Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level Inject Source 5 2 10 1 2 2 HH HH HH HH HH CH LO HI LO HI HI HI Detergent 2 CH HI Spin Time Detergent/Bleach 1 5 Total Time: 30 minutes excluding the tub fill time.
CYCLE 29 Other Oxygen Bleach Terry (No Iron) Segment Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Cycle Time Water Temp Water Level 3 2 10 2 2 2 CH CH HH HH CH CH HI HI LO HI HI HI 4 CH LO Inject Source Spin Time Detergent/Bleach 1 Sour/Soft 5 Total Time: 31 minutes excluding the tub fill time.
CYCLE Segment Cycle Time Water Temp Water Level Inject Source Spin Time Inject Source Spin Time Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Total Time: Notes: CYCLE Segment Cycle Time Water Temp Water Level Flush Pre-wash Wash Rinse 1 Rinse 2 Rinse 3 Rinse 4 Rinse 5 Final Total Time: Notes: 33