Manual

display.

6) Press and release the UP or DOWN arrow keys to change the drying temperature. Each press and

release of the arrow keys will either increase or decrease the temperature by five degrees Fahrenheit

or three degrees Celsius, depending on how your dryer controller is set up. Once either of the arrow

keys is pressed, the temperature L.E.D. and the drying temperature on the 4-digit numeric display will

flash. If you press and hold either arrow key down, you will increment (UP arrow) or decrement

(DOWN arrow) your way through the available drying temperatures (105

Fahrenheit or 40

Celsius,

up to 195

Fahrenheit or 91

Celsius). If you do not want to change the drying temperature, do not

press the arrow keys. Go to the next step.

7) Press and release the SELECT/ENTER key. Once this key is pressed and released, the temperature

L.E.D. will switch off, the dry cycle L.E.D. and programming L.E.D. will remain on, and the cool

down L.E.D. will illuminate. The cool down time will also be shown on the 4-digit numeric display.

8) Press and release the UP or DOWN arrow keys to change the cool down time. Once either of the

arrow keys is pressed, the cool down L.E.D. and the cool down time on the 4-digit numeric display

will flash. If you press and hold either arrow key down, you will increment (UP arrow) or decrement

(DOWN arrow) through the cool down times available (2 through 60 minutes). To not change the

cool down time, do not press the arrow keys. Go to the next step.

9) Press and release the SELECT/ENTER key. Once this key is pressed and released, the cool down

L.E.D. and the programming L.E.D. will switch off, and the dry cycle L.E.D. will remain on. The

flashing cool down time on the 4-digit display will stop flashing and remain.

10) At this point, you have two choices. 1) You can perform the modified dry cycle by pressing and

releasing the START key on the dryer controller touch pad, or 2) You can clear the modified dry

cycle program by pressing and releasing the STOP key once. If you start the modified cycle, the total

dry time will appear on the 4-digit numeric display and it will count down to 0 as the dry cycle

progresses. If you choose to clear the modified dry cycle, the 4-digit numeric display will change to

“LOAd”.

TEMPORARY DRYER CONTROLLER PROGRAMMING EXAMPLE

REQUIREMENTS: Dry a load with 40 minutes of actual heat at 185

F and five minutes of cool down.

The following procedure will show you how to temporarily modify the existing dry cycle 1 program for

one cycle of drying. It is based on the assumption that the factory defaults have not been permanently

changed. If they have been changed, the steps of this procedure will be the same, but the values that are

displayed will be different. The amount of times that the dryer controller touch pad UP or DOWN keys

must be pressed and released may also be different.

If you want the change to be permanent, go to the “PERMANENT DRYER CONTROLLER

PROGRAMMING” section of this manual.