Operating instructions

RAPID ADVANCE MODE

To enter the Rapid Advance mode, turn the key counter-clockwise (CCW). The Rapid Advance

setting is not marked next to the key, but turning the key CCW until it stops selects this mode.

The Rapid Advance mode can be entered from either the Idle mode or during the cycle. If the

cycle has not yet started, press the “START” button. To rapid advance to the next step in the

wash cycle, push both the “UP” and “START” buttons at the same time. The display will show

an “Ad” (advance) in the display. The washer will advance to the next bath segment. The water

will drain before the advance will occur and the time displayed may not be accurate.

Notes:

 The indicator lights will show to which segment the cycle has been advanced.

 The cycle will continue in rapid advance mode even if the key is turned to “RUN” and/or

removed.

 Rapid advance cannot skip the final 1-minute tumble of the cycle, and the door lock may

remain activated for a couple minutes after the cycle has been completed.

 The chemical injection signals will not operate in Rapid Advance mode.

To end the cycle and exit the Rapid Advance mode without waiting for the time to count down,

push and hold the STOP button for 5 seconds or more.

INJECTION SOURCE DETAILS

The washer control may be programmed to send output signals for a chemical injection system.

There is a separate terminal block for connection of the external injection signals. For the

injection sources, program codes 0 through 6 are as shown in the table below. See the

ELECTRICAL section for more information.

Dexter

Recommended

Connections

Controller

Programmed

Signals

Injection

Terminal Block

Circuits

Detergent

Bleach

Starch

Sour/Softener

A and B

C and D

None