Operating instructions

RAPID ADVANCE MODE
To enter the Rapid Advance mode, push and hold the Cold water temperature button and then
push the programming button on the controller. There will be no observed change to the washer
or the display. The Rapid Advance mode can be entered from either the Idle mode or during the
cycle. To rapid advance to the next step in the wash cycle, push the Start and Warm temperature
buttons at the same time. The display will show an “Ad” (advance) in the display. The washer
will advance to the next bath segment. The water will drain before the advance will occur.
The Rapid Advance mode will not end until the final bath segment is completed. The final
segment cannot be skipped in Rapid Advance mode.
Notes: 1. When the Rapid Advance mode is used, the cycle time will no longer be correct.
2. By skipping steps with rapid advance, the door may not open immediately at the end
of the cycle.
EASY CARD MODELS
Some Dexter washers are factory equipped with a card reader that is used with Dexter’s Easy
Card debit card system. The card reader signals the washer control when money is debited from
the user’s card account to satisfy the price of the wash cycle. The washer’s pricing and the Easy
Card system pricing are completely independent of each other and must be programmed
separately and coordinated. Refer to the instructions that came with the Easy Card system for
complete information.