User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Enabling Hyper-Threading Technology
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
28
2
Hardware Installation
PS/2 Power Select
JP1 is used to select the power of the PS/2 keyboard/mouse port.
Selecting 5V_standby will allow you to use the PS/2 keyboard or
PS/2 mouse to wake up the system.
BIOS Setting
Configure the PS/2 keyboard/mouse wake up function in the Inte-
grated Peripherals submenu (“Super IO Device” section) of the BIOS.
Refer to chapter 3 for more information.
Important:
The 5V_standby power source of your power supply must sup-
port
≥
720mA.
X
JP1
2-3 On:
5V_standby
1-2 On: 5V
(default)
132
132