User`s guide

2
EasyTouch Indoor Control Panel Installation and User’s Guide
EasyTouch Indoor Control Panel Overview
The EasyTouch Indoor Control Panel makes it easy for you to control your pool and spa daily operations from
inside your home. Using the “Pool” and “Spa” buttons allows one touch control to heat and filter your spa and
pool. EasyTouch automatic system operations can be performed either at the Indoor Control Panel or from the
outdoor control panel. The Indoor Control Panel connects to the motherboard in the EasyTouch load center.
For details about the control
panel LCD status messages,
see page 5.
AUTO HEATER
SPA 100°F / 95°F
AIR 70°F FRZ
MON 09:30 AM
AUTO HEATER
SPA 100°F / 95°F
AIR 70°F FRZ
MON 09:30 AM
Circuit LED.
Circuit name
label.
Spa (Hi-Temp) Button: Switches the filter
pump on, rotates valve actuator (to isolate
spa water from pool water), and switches
the heater on. Hi-Temp (EasyTouch single
body system) sets the high temperature
settings for the spa, see page 35.
Circuit LED.
Circuit name label.
Spa (Hi-Temp) Button:
Switches the filter pump on,
rotates valve actuator (to
isolate spa water from pool
water), and switches the
heater on. Hi-Temp
(EasyTouch single body
system), Can be assigned for
high temperature settings,
see page 35.
Pool (Lo-Temp) Button:
Switches the filter pump on,
rotates valve actuator (to isolate
pool water from spa water), and
switches heater on.
Lo-Temp (EasyTouch single body
system) sets the low
temperature settings for the pool,
see page 35.
Pool (Lo-Temp) Button:
Switches the filter pump on,
rotates valve actuator (to isolate
pool water from spa water), and
switches heater on.
Lo-Temp (EasyTouch single body
system), can be assigned for low
temperature setting, see page 35.
Indoor Control Panel (EasyTouch 8) - (P/N 520549)
Indoor Control Panel (EasyTouch 4) - (P/N 520548)
Seven user defined
auxiliary circuits.
Buttons switch the
assigned circuit
function on/off (12
hour time-out). If solar
equipment is not being
used, use the AUX
EXTRA (Down arrow
button) for an addi-
tional circuit (see page
4 for details).
Three auxiliary buttons
switch the assigned
circuit function on/off
(12 hour time-out). If
solar equipment is not
being used, use the
AUX EXTRA (Down
arrow button) for an
additional circuit (see
page 4)
Menu/Back button,
see page 4.
Set Temperature buttons,
see page 4.
Set Temperature buttons,
see page 4.