User`s guide
4
EasyTouch Indoor Control Panel Installation and User’s Guide
Controls and buttons (Continued)
Pool button (Continued)
• Single-Speed Filter Pump: If the pump is currently off, press the Pool button to switch the pump
on. Press the Pool button again to switch the pump off. However, if the heater is operating, and a
delay is enabled for valves, this allows the heater to cool down (heater cool-down), then when you
press the Pool button to switch off the pump, only the heater will turn off, then the filter pump will
automatically switch off after 10 minutes to allow the heater to cool down. Pentair Water Pool and
Spa heaters do not require a cool down time. To override the “heater cool-down,” press the Pool
button again to switch off the pump.
• Two-Speed Filter Pump: Press the Pool button to switch the two-speed pump on in high speed.
Press the Pool button again to run the pump in low speed. In order to use the “2-Speed Pump” menu
assignments (see page 40), the 2-Speed relay option must be installed in the EasyTouch Load
Center.
Notes about Freeze Protection: This function protects the pool, plumbing, and equipment against
freeze damage. If the outside air temperature sensor falls below 36° F (2° C), “Freeze Protection” is
activated and the Filter Pump relay is switched on to circulate the pool water. To enable freeze
protection for a circuit, see “Settings Menu: Circuit Functions, ” on page 37.
Liquid Crystal Display (LCD): The main system display consists of a 16 x 4 alphanumeric character
LCD with EL backlighting for easy viewing of the menu items, and status messages. Press the
Menu button twice to refresh the display. For main screen status information, see page 5.
Left button: When in pool or spa mode, press the Left button to lower the set point water
temperature. Press the Spa or Pool (Up arrow P) button (page 3) to display the current water
temperature. While in the main menu, press the Left button to scroll through sub-menu selections,
setting and values. While editing settings, press and hold the Left button to fast reverse through
settings and values.
Menu/Back button: Press the Menu/Back button to access, save and exit the EasyTouch system
menu settings. Use this button to exit from main menu or sub-menu items. Pressing the Menu/Back
button while in a menu item will return to the main status screen. If no menu activity is detected
after five minutes, the main screen is displayed. All menu settings are permanently saved and
retained in the control panel even after power is removed from the control panel. Control panel
buttons are disabled while in menu mode.
Right button: When in pool or spa mode, press the Right button to raise the set point water
temperature. Press the Spa or Pool (Up arrow P) button (page 3) to display the current water
temperature. Press the Right button to select a sub-menu item for editing. After pressing the Menu
button to access the main menu items, press the Right button to select the menu item and access the
sub-menu items for adjustment. While editing a settings, press and hold the Right button to fast
forward through settings and values.
Up/Down buttons: Press the Up and Down buttons to scroll through the main menu items and to
adjust or change settings. Use these buttons after pressing the Menu button to access the main menu
items. While editing settings, press and hold the Up or Down button to fast forward or fast reverse
through settings and values.
Down arrow button (Aux Extra): This button switches the assigned circuit on or off. This “extra”
auxiliary circuit shares the solar circuit and is only available if the solar output plug (J17) on the
motherboard is not being used for solar equipment. Refer to the EasyTouch User’s Guide
(P/N 520584) for more information.
➄
➅
➂
➃
➆
MENU
SELECT