User`s guide

8
EasyTouch Indoor Control Panel Installation and User’s Guide
EasyTouch Wireless Control Panel (Accessory)
The EasyTouch wireless control panel (8 or 4 circuits) gives you the freedom
to control your pool and spa daily operations from around your pool and spa
area. The wireless device can operate up to 300 feet from the EasyTouch
transceiver module which is typically located near the EasyTouch load center.
There is enough battery power to operate the whole summer season without
changing batteries, Using the power saving menu options you can also reduce
power consumption and extend battery life.
iS4 Spa-Side Remote Controller (Accessory)
The iS4 Spa-Side remote controller provides remote switching of up to four
control circuits from the spa location. For more information about assigning
iS4 buttons to circuits, refer to “Settings Menu: iS4 Wireless Remote,” on
page 42.
QuickTouch
®
QT4 Wireless Remote Controller (Accessory)
The QuickTouch QT4 wireless controller provides four on and off buttons to activate pool
and spa auxiliary circuits. For more information about assigning QT4 buttons to circuits,
refer to “Settings Menu: QuickTouch (QT4) Wireless Remote,” on page 40.
iS10 Spa-Side Remote Controller (Accessory)
An iS10 Spa-Side remote controller can control up to ten functions including a spa temperature adjustment.
The iS10 Spa-Side remote controller is listed UL (1563) for use with the EasyTouch systems at the water’s
edge. Five (5) in-line buttons control up to ten (10) system functions. The iS10 includes an LED display shows
the current spa water temperature. The temperature display will blink while being changed. For more
information about assigning iS4 buttons to circuits, refer to “Settings Menu: iS4 Wireless Remote,” on page 40.
EasyTouch wireless control
panel, eight circuit (P/N
520547)
POWER ON
EasyTouch Menus
MAIN SCREEN
LIGHTS
HEAT
POOL TEMP/SRC
TEMP (40˚ F - 106˚ F) OR (4˚ C - 41˚ C)
HEAT (OFF/HEATER/SOLAR/SOLAR PRF) - SOLAR/SOLAR PRF MUST BE ENABLED IN "SOLAR" MENU TO DISPLAY.
SPA TEMP/SRC
TEMP (40˚ F - 106˚ F) OR (4˚ C - 41˚ C)
HEAT (OFF/HEATER/SOLAR/SOLAR PRF) - "SOLAR/SOLAR PRF" MUST BE ENABLED IN "SOLAR" MENU TO DISPLAY.
DELAY CANCEL
MODE: SCHEDULE
08:00A -- 05:00P (12:00 AM - 11:59 PM -12 HOURS)
S M T W T F S (DAYS OF THE WEEK)
SCHEDULES
SPA 0
AUX 2 0
AUX 4 0
AUX 3 0
MODE: EGG TIMER
TIME: 12:00 (00:00 - 23:59) / DON'T STOP
(DELAYED CANCELLED) PRESS RIGHT BUTTON TO ACTIVATE
POOL 0
AUX 1 0
AUX 5 0
AUX 6 0
AUX 7 0
EASYTOUCH 4
EASYTOUCH 8
MODE: ONCE ONLY
08:00A (12:00 AM - 11:59 PM -12 HOURS)
S M T W T F S (SELECT DAY OF THE WEEK TO RUN PROGRAM)
MODE: NEW / DELETE / NONE
HI-TEMP (SPA) / LO-TEMP (POOL) FOR SINGLE BODY SYSTEM (SEE SETTINGS MENU: CIRCUIT NAMES)
FEATURE 1-8 0
AUX EXTRA: AUXILIARY OUTPUT (USE DOWN ARROW BUTTON TO SWITCH ON/OFF). ONLY AVAILABLE IF
SOLAR PLUG (J17) IF NOT BEING USED FOR SOLAR EQUIPMENT.
MODES [6 LIGHT SHOWS, HOLD, RECALL, COLOR SWIM, COLOR SET]
COLORS [5 FIXED COLORS, HOLD, RECALL, COLOR SWIM, COLOR SET]
ALL ON (SWITCH ALL LIGHTS ON)
ALL OFF (SWITCH ALL LIGHTS OFF)
SYNC (SYNCHRONIZE COLORED LIGHTS)
MAGICSTREAM [TOGGLE THUMPER, HOLD, RESET, CHANGE MODE]
CONFIG (SETUP EIGHT LIGHT POSITIONS)
FEATURE CIR
FEATURE 1-8 [OFF]
AUX EXTRA 0
FEATURE 1 - 8
MANUALLY TURN A FEATURE CIRCUIT ON/OFF.
USE FEATURE CIRCUITS TO CONTROL PUMP SPEEDS AND VALVES.