User`s guide

EasyTouch Indoor Control Panel Installation and User’s Guide

Cabling the Indoor Control Panel at the Load Center

To connect the indoor control panel cable to the motherboard:

1. Turn off the main system power before making any connections.

2. Run a UL approved four conductor cable (22 AWG) from the indoor control panel to the Load

Center. The preferred wire color scheme is: Red, yellow, green, and black.

3. Route the cable up through the low voltage raceway to the motherboard.

4. Strip back the communication cable conductors ¼ in. Insert the wires into the screw terminals

(provided in the kit). Secure the wires with the screws. Make sure to match the color-coding of the

wires: Red = +15, Yellow = +DT, Green = -DT, and GND = Black.

5. Insert the cable plug onto the COM-PORT (J20) connector.

6. Proceed with Mount and Cable the Indoor Control Panel, page 64.

COM PORT

(J20)

Indoor Control Panel

IntelliChlor

IntelliFlo

RF Transceiver

EasyTouch Motherboard