Installation Instructions

816Bluetooth Module Manual

1，The power supply voltage of bluetooth module is 12V-80V, with 3.3V enabling

foot switch, enabling switching voltage is 3V-5V, audio output is differential output,

and the output power is 4EURO 3W.

2. Job Description:

Bluetooth module is powered on, the controller outputs high level to a 3.3 V can make

feet, can make the feet to 12 p10 the MOS conduction, the whole module which begin

to work, after the success of the bluetooth connected with mobile phone via bluetooth

pass bluetooth chip, the audio audio signal to the bluetooth chip output difference

HT6872 amplifiers, audio after amplification push 4 r3w trumpet playing out.

3，（OEM) Integrator has to assure compliance of the entire end-product incl. the

integrated RF Module.

For 15 B (§15.107 and if applicable §15.107) compliance, the host manufacturer is

required to

show compliance with 15 while the module is installed and operating.

Furthermore the module should be transmitting and the evaluation should confirm that

the module's

intentional emissions (15C) are compliant (fundamental / out-of-band). Finally the

integrator has

to apply the appropriate equipment authorization (e.g. Verification) for the new host

device per

definition in §15.101.

Integrator is reminded to assure that these installation instructions

will not be made available to the end

user of the final host device.

The final host device, into which this RF Module isintegrated" hasto be labelled

with an auxilliary lable stating the FCC IDofthe RF Module,

such as "Contains FCC ID:2AANZIDL

"This device complies with part 15 of the FCC rules. Operation is subject to the

following two

conditions:

(1)this devicemay not cause harmful interference, and

(2)this devicemust accept any interference received, including

interference thatmay cause undesired operation."

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable

protection

against harmful interference in a residential installation. This equipment generates,

uses and can

PAGE 1
816Bluetooth Module Manual 1，The power supply voltage of bluetooth module is 12V-80V, with 3.3V enabling foot switch, enabling switching voltage is 3V-5V, audio output is differential output, and the output power is 4EURO 3W. 2. Job Description: Bluetooth module is powered on, the controller outputs high level to a 3.
PAGE 2
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 3
Integration instructions for host product manufacturers according to 816 Manual v01 2.2 List of applicable FCC rules FCC Part 15.247 2.3 Specific operational use conditions This transmitter/module and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. This information also extends to the host manufacturer’s instruction manual. 2.4 Limited module procedures not applicable 2.
PAGE 4
the resulting composite system does not exceed the spurious emissions limits or band edge limits (e.g., where a different antenna may be causing additional emissions). B. The testing should check for emissions that may occur due to the intermixing of emissions with the other transmitters, digital circuitry, or due to physical properties of the host product (enclosure).