Installation Instructions

Integration instructions for host product manufacturers according to 816
Manual v01
2.2 List of applicable FCC rules
FCC Part 15.247
2.3 Specific operational use conditions
This transmitter/module and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter. This information also extends to
the host manufacturer’s instruction manual.
2.4 Limited module procedures
not applicable
2.5 Trace antenna designs
It is “not applicable” as trace antenna which is not used on the module.
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This compliance to FCC radiation exposure limits for an
uncontrolled environment, and minimum of 5mm separation between antenna and
body.
The host product manufacturer would provide the above information to end users in
their end-product manuals.
2.7 Antennas
The module equipped with PCB Antenna（-0.318dBi, 2.402 GHz to 2.480GHz）
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labeling followed
KDB784748D01 and KDB 784748 stating “Contains Transmitter Module FCC ID:
2AANZIDL”.
2.9 Information on test modes and additional testing requirements
Information on test modes:
The host manufacturer can use software for access to the test modes. Connected to the
device through the serial port of the host product and control the module. If it does not
work, then the host product manufacturer should coordinate with the module
manufacturer for access to test mode software.
The following provides guidance to host product when installing this module on
how they may verify the end product:
A. If the modular transmitter has been fully tested by the module grantee on the
required number of channels, modulation types, and modes, it should not be
necessary for the host installer to re‐test all the available transmitter modes or
settings. It is recommended that the host product manufacturer, installing the
modular transmitter, perform some investigative measurements to confirm that