4 in 1 HEPA-Plasma Air Purifier INSTRUCTION MANUAL
Table of Contents Introduction Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 The Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 How It Works . . . . . . . .
Safety Instructions READ THESE SAFETY INSTRUCTIONS BEFORE USE ! ! ! ! ! ! ! 2 When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: WARNING: to reduce the risk of fire or electric shock, do not use this device with any solid-state speed control device. Read all the instructions before operating ! Children should not use this equipment the unit. alone.
Safety Information (Cont.) Battery Precautions ! WARNING: This product contains a lithium button/coin cell battery. If a new or used lithium button/ coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. If you think batteries might have been swallowed, seek immediate medical attention. ! Incorrect battery usage may cause battery fluid leakage and/or damage. ! When not using remote for extended periods of time, remove the battery.
How It Works CONTROL PANEL REMOTE CONTROL CHASSIS HEPA 4-IN-1 FILTER The CleanAire 4 in 1 HEPA-PLASMA Air Purifier incorporates a 6-stage cleaning system to help clean the air. A fan forces air through the unit from bottom to top. There are six stages to the unit: • Stage 1: Plasma Wall Set. The plasma wall set enlarges the diameter of particles and generates an electrostatic magnetic field, thus improving the downstream filter's absorption rates. • Stage 2: Pre-Filter.
Operation Instructions Product Specifications Power Consumption Input Voltage Operating Temperature Range Storage Temperature Range Dimensions (LxWxH) Applicable Room Size Net Weight CADR Remote Control Dimensions 62 Watts 100-240 VAC 50/60 Hz 32° F to 95° F (0°C to 35° C) -40° F to 158°F (-40° C to 70° C) 13.6 X 9.13 X 35.18 inches (347 X 232 X 893mm) 538.2 ft2 (50m2) 21.6 lbs (9.8 kg) 300 CFM (510m3/h) 1.77 X 0.79 X 4.
Icon Description Sleep Mode Button. Press this button to place the unit in sleep mode. In sleep mode the fan runs at ultra-low speed for silence, and the light ring turns off. Fan Speed Button. Use this button to adjust the fan speed, toggling through the 1-2-3 fan speeds. An indicator corresponding to the selected fan speed will illuminate. When the unit is in Auto mode or Sleep mode, pressing the Fan Speed button will cancel either mode. Plasma On/Off Button.
Operating Modes There are three operating modes for the Purifier. When the Purifier is turned on, the mode of operation will return to the mode used the last time it was operated. • Normal Mode In Normal mode the Purifier operates at a fixed fan speed. Press this button repeatedly to toggle the fan speed between 1-2-3 speeds. Using the Remote Control The Remote Control duplicates the functions of the corresponding buttons on the Control Panel.
Follow these instructions to use the AiLivin app. 1. Plug in your machine to the electrical outlet and turn on the power. 2. To disable or enable the WiFi press and hold the ON/OFF button on the machine for 3 seconds. 3. Open the AiLivin app and follow the instructions to create a new account if you do not already have one. 4. Follow the on-screen instructions to pair your machine to the AiLivin app.
Remote Battery Replacement 1. Detach magnetic cover 3. Replace magnetic cover 2. Remove and replace filter ! WARNING This product contains a lithium button/coin cell battery. If a new or used lithium button/ coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. 1.
Troubleshooting Symptom Purifier does not operate. Purifier is starting to make noise and the air output is low. Air coming from Purifier has a bad odor. Air quality does not improve as the Purifier operates. Fan does not operate. Fan speed does not change after selecting a new fan speed. 18 Probable Cause/Solution Power cord not securely plugged into outlet. Make sure plug is securely inserted. No AC power. Check fuse or circuit breaker.
Customer Assistance PRODUCT WARRANTY A. This 2 year limited warranty applies to For assistance with your repair or replacement of product found to CleanAire 4 in 1 HEPA-Plasma Air Purifier, be defective in material or workmanship. This warranty does not apply to damage call our Customer Service Line: resulting from commercial, abusive, unreasonable use or supplemental damage. 1-855-384-7754 Defects that are the result of normal wear and tear will not be considered manufac8 a.m. - 5 p.m.
22 FCC statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2)this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.