Instruction Manual

10 11
Icon Description
Sleep Mode Button. Press this button to place the unit in
sleep mode. In sleep mode the fan runs at ultra-low speed for
silence, and the light ring turns off.
Fan Speed Button. Use this button to adjust the fan
speed, toggling through the 1-2-3 fan speeds. An indicator
corresponding to the selected fan speed will illuminate. When
the unit is in Auto mode or Sleep mode, pressing the Fan Speed
button will cancel either mode.
Plasma On/Off Button. Press the icon to toggle the plasma
sterilization function on or off. This setting will improve the
sterilization ability, and particularly recommended in cold and
flu seasons. NOTE: This button is not on the Remote Control.
Filter Replacement Indicator/Button. Indicator will illuminate red
when the HEPA filter needs to be replaced. After replacing the
filter, press and hold this button for 3 seconds to reset the filter
life countdown.
Timer Button. The Timer Button allows you to select how long
the machine will run before it automatically shuts off. There
are three pre-set times: 2, 4 and 8 hours. Press the icon toggle
through the options (2H-4H-8H-None). Once selected, an
internal timer controls operation of the unit for the selected
duration. Once the timer expires, the unit shuts down and
enters the standby mode. NOTE: Do not use this option if you
want the unit to run continuously.
WiFi Status Indicator/Button (WiFi equipped models only).
Illuminates to indicate WiFi connection function or status:
•
Flashing green: Attempting to connect
•
Steady green: Connection successful
•
Steady red: Not connected
The button is also used to disconnect from WiFi when it is
connected. Press the button a second time and it will attempt
to reconnect.
Preparation for Operation
If you haven't already done so, detach
the bottom cover, remove the 4-in-
1 HEPA filter from the plastic bag, and
install it in the unit. Replace the bottom
cover.
WiFi Setup
When you first turn on the unit, it
will attempt to connect to your WiFi
network. Follow these steps to connect
your unit.
1. On your smartphone, install the
AiLivin app and turn your Bluetooth
function on.
2. Turn on the power to the unit.
3. Open the AiLivin app and add the
device.
4. When the app indicates, press
and hold the WiFi Status Indicator/
button for 3 seconds.
5. The app should connect to the
device over your WiFi network and
the WiFi Status Indicator/Button will
illuminate green.
To disconnect from the network, press
the WiFi Status Indicator/Button. The
unit will beep and the indicator will
flash red.