User Guide

PG7000, RPM, PPC and MPC are trademarks, registered and otherwise, of DH Instruments, Inc.
Document 560003f 031103
DH Instruments, Inc.
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Tel [phone]
Fax [phone]
[e-mail]
www.dhinstruments.com
PG7000™/RPM™ to PPC™/MPC™
Interconnections Kit
Installation Sheet
INTERCONNECTIONS KIT, P/N 400985,
INCLUDES
QTY PART NO DESCRIPTION
2 100319 Adaptor, 1/8 in. Tube x 1/8 in. NPTM
1 100327 Tee, 2T
1 101563 Filter, 2T
1 101980 Union, 2P
1 101982 Reducer, 4P x 2P
2 101988-Z Tubing, SS, .125 OD x 100 cm LG
1 102115 Quick Connect, AN4M
1 102116 Quick Connect, 1/8 in. NPTF
1 401459 Quick Connect and Stand Assembly
PARTS ON TEST PORT OR IN
ACCESSORIES OF PG7000
1 101200 Collar
1 100272 Gland
1 400518 1/8 in. Tube x DH 200 M Adaptor
TO PNEUMATICALLY CONNECT THE
PG7000 OR RPM TO THE PPC OR MPC
If you are using an RPM (not a PG7000) go directly
to Step pb.
n Remove gland, collar and plastic plug from the
PG7000 TEST port.
o Install gland and collar onto 1/8" tube x DH200 male
adaptor supplied in PG7000 accessories.
The collar threads left- handed. Ensure it is
securely attached. The plastic plug is not used.
pa PG7000 - Screw the adaptor (as assembled) into the
PG7000 test port. Torque to 15 Nm (Newton meter).
pb RPM3 - Screw 1/8 in. tube x 1/8 in. NPT male adaptor
into the RPM3 test port using teflon tape as seal.
q Connect tee and filter assembly to quick connect
stand assembly.
r Screw 1/8 in. tube x 1/8 in. NPT male adaptor into
PPC test port using Teflon tape as a seal.
s Mount quick connect stand on bench (mounting
holes provided).
t To connect PG7000 or RPM3 test port to the quick
connect stand cut 1/8" SS tubing to desired length
and Swage nut together.
u To connect PPC to the quick connect stand cut
1/8 in. SS tubing to desired length and Swage nut
together.
1/8 in. SS tubing can be bent by hand to
desired shape but use caution not to kink the
tube.