Specifications

PA/4000 User’s Manual
Appendix D, Replaceable Components and Supplies
Page 2
Replaceable Components Continued
Part Number
Component Description
6105-322 Vacuum filter cartridge
6105-061 Rewind belt
6105-050 Stepper motor cable assembly
6105-048 Transformer cable assembly
6105-047 Label low sensor cable assembly
6105-046 Paper edge sensor cable assembly
6105-045 Ribbon sensor cable assembly
6105-036 Peel blade
6105-026 Pinch roller spring
6600-202 Heat sink compound
7501-021 Filter replacement element
Media Supplies
Labels
Diagraph recommends its LTS line of labels for thermal transfer printing, and its
ATS line for direct-thermal printing. Stock sizes can range from 2 inches (50.8
mm) wide by 1 inch (25.4 mm) long to 4.5 inches (114.3 mm) wide to 13.00 inches
(330.2 mm) long, printable area 4.1 inches left justified. LTS labels are made from
a coated, thermal transfer facestock, which readily accepts ribbon transfer.
Labels are sold in full case quantities only.
ATS labels are made from a premium thermal face sheet for optimum
environmental resistance. They are designed to provide excellent print contrast
when printing bar codes.
Label edge sensing is carried out by an adjustable photosensor. This sensor
locates the leading edge of a label, by measuring the level of opaqueness. You
can move it left and right to accommodate different sensing locations (label edge
or backprinted, black stripe). The black stripe sensor locates the leading edge of
a label by measuring the level of reflectivity instead of a change in opaqueness.
Media thickness can range from 0.0023-inch (0.06 mm) to 0.01-inch (0.25 mm).
Supply rolls have cores with a minimum inside diameter of 3 inch (38 mm). The
maximum roll diameter should not exceed 12 inches (203 mm).