Specifications

Technician’s Guide 2-38
Figure 2-6
7. Place a flat washer and a lock washer on each of the screws provided.
8. Insert the top screw (#8-32 S.H.C.S.) through the ribbon low sensor assembly and
tighten.
Be sure that the Ribbon Low Sensor Assembly lays flat against the surface of the
PA/4000. You may need to adjust the angle supporting the hinged plastic cover to
accomplish this.
9. Align the plastic tie wrap mount with the hole in the PA/4000 as shown in Figure
2-6.
10. Secure the plastic tie wrap mount to the PA/4000 using the #6-32 flat head screw.
11. Insert the bottom screw (#8-32 S.H.C.S.) through the ribbon low sensor assembly
and tighten.
12. Secure ribbon low sensor cable to the tie wrap mount using tie wraps.
13. Route loose end of the ribbon low sensor cable through the electrical box assembly
and connect it to J6 on the applicator logic board.
14. Secure loose ribbon low sensor cable with tie wraps. Give yourself enough slack in
the cable to allow for the stress caused by closing the electrical box.
15. Close the electrical box. Be sure that the cutter cable stays in place.
16. Replace the two screws which hold the electrical box in place.
17. Return the PA/4000 to its original position.
18. Place new ribbon supply on supply spindle.
19. Re-connect all air hoses and electrical cables, open air valve and turn the power
switch to the ON position.
20. Place installation label, (Ribbon Low Kit Installed) next to serial number label after
the system has been tested.