Specifications

PA/4000 User’s Manual
Section 4, Installation
Page 1
4.0 INSTALLATION
4.1 Overview
Instructions in this section show the PA/4000 in a top down configuration, that
is with the print engine upright and labels applied on top of the product. The
size of the PA/4000 necessitates two people for installation.
Review Section 1.1 for power and air requirements.
Tools: Installation and configuration of the PA/4000 requires the tools
listed below:
• Set of socket wrenches with a socket as big as 1 1/8 inch
• Utility knife
• Sets of Allen wrenches, U.S. and metric
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• Small slotted tip screwdriver
• Medium slotted tip screwdriver
• Diagonal cutters
• 9/16 inch box wrench
• 15/16 inch open-end wrench (optional)
4.2 Assembling the Stand
Parts:
1 Tee base
1 Upright post
1 Nut for upright to base connection
1 Crank handle
1Yoke
Assembly:
1. Position the upright post on the tee base and tighten in place
with the nut, flat washer and lock washer provided.
2. Lock casters to prevent the stand from rolling during assembly.
3. Place the crank handle on top of the post for height adjustment of
the yoke mounting plate.
4. Attach the yoke to the mounting plate with the washer and nut
provided.
5. Once the unit is positioned on the line for print and apply
operation, bolt the unit to the floor through the 3 holes provided on
the t-base of the stand.