Specifications

PA/4000 User’s Manual
Section 4, Installation
Page 4
4.4 Mounting Attachments to the Main Unit
4.4.1 Attaching the Label Supply Disc
Parts: 1 Aluminum Rear Label Supply Disc
[A]
1 Smokey Plexiglass front Label Supply Disc
[F]
Assembly: 1. With an Allen wrench, loosen the set screw
[D]
on the
plastic collar that is attached to the aluminum rear label
supply disc.
2. Slide the aluminum rear label supply disc
[A]
(with the
collar facing toward you) onto the label supply hub. The
label sensor slot
[C]
on the disc allows the label low sensor
[B]
to sense when the label roll gets low. After the disc is in
position tighten the set screw
[D]
with an Allen wrench,
3. Load the label roll onto the hub
[E]
(see label loading
instructions in Section 4.13).
4. Slide the plexiglass smoke-colored front label supply disc
onto the label supply hub
[E]
. It will be a tight fit so you
will need to tap it in gently. Be sure that the flanged collar
fits into the label roll core.
[D]
[A]
[B]
[C]
[E]
[F]