Specifications

PA/4000 User’s Manual
Section 4, Installation
Page 5
4.4.2 Attaching the Air Cylinder/Tamp Pad
Parts: 1 Air Cylinder/Tamp Pad
1 Support bar and hardware
Assembly:
1. Slide the air cylinder/tamp pad assembly
onto the extended horizontal support bar
[A]
on the PA/4000 main unit.
2. Position the assembly so the tamp pad
[C]
rests 3/16 inch
[D]
from the peel
blade
[E]
on the print engine. Before
you tighten the assembly into position,
manually extend the tamp pad
[C]
to
make sure that it will not hit the air
assist tube
[F]
. Tighten the two 10-32
socket head screws
[B]
using a 3/32
inch Allen wrench.
3. Fully retract the tamp pad. The bottom
of the tamp pad
[C]
should be 1/16
inch
[G]
lower than the peel blade
[E]
position. To attain this, adjust the stop
bolt
[H]
.
4. Plug the cable into J5 of the electrical
panel on the rear of the main unit, see
Section 4.12. Plug in and power ON
the system.
5. The cylinder home switch
[I]
(located
near the top of the cylinder) must be
positioned so that the red LED is ON
when the cylinder is fully retracted and
the stop bolt
[H]
is against the tamp
pad. Loosen the set screws
[J]
with an
Allen wrench and move the cylinder
home switch up or down until the LED
lights. Tighten the set screws
[J]
.
[F]
[C]
[E]
[G]
[D]
[I]
[J]
[H]
[B]
[A]