Specifications

PA/4000 User’s Manual
Section 4, Installation
Page 10
4.9 Mounting the Optional Warning Tower to the Stand
If your system does not have a warning tower, move to the next section.
Parts: 1 Warning Tower
[A]
with cable
[D]
, mounting plate and
hardware
[B]
(P/N 6150-320)
Assembly: 1. Screw the mounting plate
[B]
onto the stand
[E]
with the 1/4
inch Allen bolts provided using a 3/16 inch Allen wrench.
2. Loosen the cable grommet and the adjacent nut on the end
of the warning tower. Let the grommet and nut slide
down the cable.
3. Holding the tower upright, pass the tower through the slot
in the mounting plate
[B]
. Tighten the nut under the
mounting plate and re-attach the cable grommet.
4. Plug the DB9 plug into connection J4 on the electrical panel
on the back of the print engine
[C]
(see Section 4.12) and
hand tighten the jackscrews.
[A]
[B]
[E]
[D]
[C]