Specifications

PA/4000 User’s Manual
Section 6, Operations
Page 1
6.0 OPERATIONS
6.1 Start of the Day
Step 1 – Check Configuration.
Look at the configuration sheet attached to the PA/4000 (see page 3 of this
section). Check all system settings against those recorded on the sheet.
Step 2 – Check Power.
1. Check that the OSHA air valve is in the CLOSED position.
2. Turn ON the power.
3. Check the air pressure.
4. Check the positions of all switches.
Step 3 – Check Consumables.
1. Check that there is a label roll loaded. Make sure that it is routed
correctly. See Section 4.13.
2. Check that there is a ribbon roll loaded. Make sure that it is intact
and routed correctly through the print engine. See Section 4.14.
Step 4 – Start Up.
1. If there are no problems or errors, the Hand-Held Terminal will
display “All OK”.
2. Press the PAUSE/RESUME key once. The display will read
“Printer Paused”.
3. Slide the air shut-off valve to the OPEN position.
Step 5 – Download Format.
1. At the PC send a batch of labels to the PA/4000.
2. Press the PAUSE/RESUME key once to enter print mode.
3.
Note that the printer will expel two more labels after you expel
the first label. Remove these labels and send one more test
label to be sure that the PA/4000 is ready.
Step 6 – Turn on Conveyor.