Specifications

PA/4000 User’s Manual
Section 6, Operations
Page 3
Serial No.__________________________________________________________________
Production Line_____________________________________________________________
THESE VALUES SHOULD ONLY BE CHANGED BY MAINTENANCE OR OTHER TRAINED PERSONNEL
HAND HELD MENU SETTINGS
The values recorded on this sheet will be different from one production line to the next. Factors
such as line speed, distance from the PA4000 tamp pad to the product, and the location of the
product sensor will determine the actual values.
* Not a stored variable
**Line speed, tamp distance and other factors will determine actual value.
AIR CONTROL PSI SETTINGS TAMP CYLINDER FLOW CONTROLS
See Section 5.4.1 for instructions on how to set air
flow controls. After air flow has been adjusted,
record here as a reference how many full turns
clockwise was made to attain the final settings.
Once set, do not change these settings.
RE
V
I
S
I
ON
2
.0
3/
1
7/00
PA/4000
CONFIGURATION SHEET
Menu
Clear Count* NO
Tamp Dwell**_________
Product Delay**_______
Output Delay**________
Output pulse**________
Sensor #1 Edge L T
Sensor #2 Edge L T
Output Sensor 1 2 NC
Auto Retract ON OFF
Darkness________________
Transfer ON OFF
VACUUM
0
20
40
60
80
100
120
140
160
AIR ASSIST
0
20
40
60
80
100
120
140
160
TAMP
0
20
40
60
80
100
120
140
160
Draw in a line to
represent the needle
position and/or
write in the box an
approximate
numeric value.
_______________CW*
_______________CW*
*Number of turns clockwise relative to fully ccw position