Use and Care Manual

Page 7 of 12
UNPACKING AND INSTALLING CASTERS
• Keep the evaporative cooler in an upright position and remove the packaging.
• Make sure all the parts are present: Castors (4pcs) & Screws (16pcs), Ice Pack (2 pcs).
• Lay the evaporative cooler on its side gently. Locate screw holes for the casters under the
Reservoir. Use the screws provided to fasten the casters to the underside of the Reservoir. Set the
cooler right-side up when the casters are installed.
CONTROL PANEL OPERATIONS
Use this dial to select fan speed. To turn “on” the fan, turn “FAN” dial from “OFF”
to “L”, “M” or “H” (Low, Medium or High).
To activate evaporative cooling turn “PUMP” dial from “OFF” to “ON”.
Ensure that the water level is sufficient for the operation.
If this function is not turned on the unit operates as a fan / air cleaner.
To activate the swing mode turn “SWING” dial from “OFF” to “ON”. The airflow will
swing from left to right. The up-down airflow can be controlled manually by
adjusting the horizontal louvre.